AIM Evo4s Data Logger

The Aim EVO4s Data logger is the new powerful and flexible datalogger, an evolution of the well known EVO4. It maintains the same one connector per channel connection logic, but with a completely redesigned internal electronic board. Aim EVO4s is fully compatible with the last generation of Aim dash/displays and with the new powerful Race Studio 3 software. The EVO4S car racing datalogger samples all the information you need via data coming from your vehicle ECU via CAN, RS232 or K-line, from the internal accelerometers and gyro, from the GPS08 module included in the kit. From analog/digital inputs, external expansions as well as predefined math channels. Sensors can be connected to 5 configurable analog channels, to the RPM input and to 2 wheel speed inputs.

Many sensors can be connected to Aim EVO4s via: 5 Analog channels with configurable 12 bit 0-5 Volt, 0-500 mV, 0-50 mV inputs or thermocouple input, used to sample data coming from temperature, pressure, suspension and other kinds of sensors. 2 Speed inputs, which allow to monitor the different wheels behavior. 1 RPM input, which manages square wave signals transmitted by the ECU, or pulse signals picked from the coil command (low voltage).

Technical Specs:

LEDs: 1 system status

CAN connections: 2 ECU connections: CAN, RS232 or K-Line ECU compatibility: + 1,000 industry leading ECUs Expansion

CAN connection: GPS, Channel Expansions, Thermocouple Expansions, Lambda Controllers, SmartyCam HD

Analog inputs: 5 fully configurable, max 1,000 Hz each

Digital inputs: 2 Speed inputs, lap signal, coil RPM input

Digital outputs: 1 (1 Amp max)

Accelerometer: Internal Three-axial ± 5G + Three-axial Gyroscope

Internal memory: 4 GB

Body: Anodized aluminum

Connectors: 13 Binder connectors

Dimensions: 130 x 35 x 46.6 mm

Weight: 330 g

Power consumption: 350 mA

Waterproof: IP65